Complete Air Filter Box Assembly for Suzuki Access 125 Old Model – Full Air Cleaner Case Outer Housing Set with Intake Connecting Boot & Internal brackets (Premium Impact-Resistant Polypropylene | Air-Tight Rubber Gasket Matrix)

High-Impact Polypropylene Body: Molded from premium, heavy-gauge automotive structural polymer that resists heat degradation, petroleum warping, and stone chipping.

Airtight Joint Perimeter: Features factory-machined mating edges and robust mounting screw bosses to ensure a perfect, dust-proof internal vacuum seal.

Flexible Reinforced Intake Boot: Includes a pre-installed, ozone-resistant rubber connecting hose that fits tightly over the carburetor intake to block out moisture.

Acoustic Dampening Matrix: The interior chamber geometry balances intake air pulses to lower loud sucking engine noise for a quieter commute.

Direct Factory Fit Mounts: Sized precisely to line up with the original crankcase mounting points, eliminating lateral wobbling or rattling over rough city roads.

Factory Part No Reference: 13700-33G40 Equivalent

Stop Dust Intake, Curing Low-Speed Bogging, and Secure Factory Air Filtration Sealing

Riding your scooter with a cracked, warped, or improperly seating air filter box allows unfiltered, grit-laden ambient air to bypass your filtration element entirely. This raw dust streams straight into your carburetor and engine cylinder, scoring the piston rings, lowering engine compression, and permanently destroying your mileage. On the legacy Suzuki Access 125, the air filter housing sits low next to the rear swingarm, exposing it to kicking gravel, continuous chassis vibration, and engine heat cycles. Over time, the plastic mounting tabs break off, the casing warps from exhaust heat, or the carburetor connecting boot develops micro-cracks. This breaks the critical vacuum pressure, leading to an irregular air-fuel ratio that causes hard cold-starting, sluggish throttle pick-up, and high-speed engine missing.

Our premium Air Filter Box Complete Suzuki Access 125 Old (SKU: AFBSA125O) delivers a complete workshop-grade replacement to safeguard your motor. injection-molded from heavy-duty, high-impact automotive polypropylene, this assembly resists cracking under high ambient temperatures and repels flying road debris. The chamber features a precision-machined perimeter wall that forms an absolute airtight seal when fastened down, preventing dirty air from seeping past the edges. Outfitted with a highly resilient, flexible rubber intake connecting boot that fits securely over the carburetor throat, this direct replacement housing balances internal pressure waves, yielding smooth engine performance, predictable idling, and peak fuel efficiency.

❌ Generation Model Fitment Warning: This specialized intake housing is measured strictly to fit the older steel-body carburetor versions of the Suzuki Access 125. It will not fit newer Suzuki Access 125 SE (Telescopic/Fi Models), Access 125 BS6 (Fuel-Injected), Suzuki Burgman Street 125, or Suzuki Avenis 125 models. Those newer generations utilize distinct oval-shaped throttle bodies, completely separate chassis subframe clearances, and multi-sensor routing layouts.